Added 4 external slave devices and 1 internal master in the EX_PD mode, then, switched to CTS mode to test one slave, but in the I3C network it’s displaying there are still four slaves devices on the bus and couldn’t identify which slave is the target device?
sudeshna roul Changed status to publish
When switching the mode of operation from EX-PD to CTS, we recommend performing ResetAll on the PGY-I3C-EX-PD unit and then switching the mode of operation to CTS. Once this is done, the user can configure 1 Prodigy Master (Controller) and 1 External Slave Device (Target) in the software and proceed to run the slave test cases for CTS. This will also ensure that there is only 1 Master and slave device present on the bus.
Prodigy Development Changed status to publish
Write your answer.